IndiaBIX

Computer Science - Computer Hardware

Exercise : Computer Hardware - Section 6
1.
A PCMCIA measuring 10.5mm is what type?
type 1
type 2
type 1 and 3
type 3
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
2.
What component would most likely cause a "parity error"?
bad hard disk
bad controller
bad RAM
bad software
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
3.
Whenever you have a hardware resource conflict, it will more likely be an IRQ conflict rather than an i/o conflict because:
there are a lot more I/O addresses than IRQs.
the BIOS sometimes has more of a problem controlling IRQs
I/O addresses cannot conflict
software tends to correct I/O conflicts
software tends to mess up IRQs
Answer: Option
Explanation:
No answer description is available. Let's discuss.
4.
You have just installed a new internal PCI modem on you desktop. It will not dial out. what is the problem?
The port speed is set too high
the modem has not been set up in control panel properties
the phone line is plugged into the line-in port on the modem card
the phone line out of the wall is plugged into the phone port on the modem card
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
5.
After you service a laser printer, you notice dirty print. Which of the following would correct the problem.
Clean the developer tank
Reset the printer
Run several blank pages
Clean the laser diode
None of the above
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers