Civil Engineering - Surveying - Discussion

Discussion Forum : Surveying - Section 2 (Q.No. 3)
If the angular measurements of a traverse are more precise than its linear measurements, balancing of the traverse, is done by
Bowditch's rule
Transit rule
Empirical rule
all of the above.
Answer: Option
No answer description is available. Let's discuss.
11 comments Page 1 of 2.

Shokat said:   8 years ago
Balancing of travers is done by?

D.c. said:   8 years ago
Reducing the error of closure is the balancing.

Bhusha nilekar said:   7 years ago
We can also do this by Bowditch and Empirical. I think option D is correct.

Santhosh C said:   7 years ago
In Bowditch method, both angular and linear are given equal precision.

In axis method, angular measurements are measured accurately and corrections applied to linear measurements only.

Arfan riaz said:   6 years ago
I think option D is correct.

Aman said:   6 years ago
Can anyone explain clearly?

Akkki said:   6 years ago
Balancing is done by two methods 1 transit and 2 Bowditch.

If angular measurement are precise then transit method is used.

If linear measurements are precise than angular then Bowditch method is used.

Pankaj said:   5 years ago
Bowditch rule = this rule is used to balance the traverse when angular and linear measurement are (equally) precise.

Transit rule = this rule is used when angular measurement is (more) precise than linear measurement.

RaJesh said:   4 years ago
Yes. You are correct, thanks @Pankaj.

Mariyadass selvam said:   4 years ago

All three options are used for balancing the closed traverse and if angular measurements are more precise than linear measurements then the answer is transit rule.

Post your comments here:

Your comments will be displayed after verification.