Civil Engineering - Steel Structure Design - Discussion
Discussion Forum : Steel Structure Design - Section 2 (Q.No. 30)
30.
The minimum pitch of rivet holes of diameter d should not be less than
Discussion:
5 comments Page 1 of 1.
Ram said:
9 years ago
Maximum is 1.5d.
Drz said:
8 years ago
Maximum 1.5d minimum 0.33d.
Nik said:
7 years ago
2.5times nominal diameter.
Raj kumar said:
7 years ago
The minimum should take 2.5 times of d.
Bilawal Khan said:
4 years ago
The minimum margin provided against tearing of plate is = 1.5d.
the minimum pitch is = 2.5d.
The maximum pitch is= 32t or 300mm whichever is smaller.
the minimum pitch is = 2.5d.
The maximum pitch is= 32t or 300mm whichever is smaller.
(4)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers