IndiaBIX

Civil Engineering - Steel Structure Design - Discussion

Discussion Forum : Steel Structure Design - Section 1 (Q.No. 22)
Steel Structure Design
22.
Pick up the incorrect statement from the following:
The nominal diameter of a rivet is its diameter before driving
The gross diameter of a rivet is the diameter of rivet hole
The gross area of a rivet is the cross-sectional area of the rivet hole
The diameter of a rivet hole is equal to the nominal diameter of the rivet plus 1.5 mm
None of these.
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
14 comments Page 1 of 2.
ASPIRANT said:   3 years ago
Option C is right because in gross area cal. hole dia is not taken into consideration.

While option D may be correct in such a condition when rivet NOMINAL DIA.<or = 25.
Rohan Mukherjee said:   5 years ago
The question has insufficient data! The answer must be E.
Pramit Samanta said:   5 years ago
According to LSM.

If nominal dia < 14 mm then hole dia = nominal + 1.
If nominal dia < 24 mm then hole dia = nominal + 1.5.
If nominal dia > 24 mm then hole dia = nominal + 2.
(2)
Pavan said:   6 years ago
All are correct only.
But for Option D, until unless there z mention of bolt size, we can't say the exact one.
We may go for D here.
(1)
Vasu said:   7 years ago
Why not B? Please explain.
Himangshu said:   7 years ago
The correct answer is C. I agree.
Vipin pandey said:   7 years ago
D is correct. I agree with the given answer.
Ricks said:   7 years ago
Yes, D is the right answer as the question says choose incorrect one which is incorrect it not mentioned the limit of diameter.
Rahul said:   8 years ago
@Lakhwnder singh.

It is 25 not 24.
C.s.roy said:   8 years ago
I think the correct option is C.
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers