Civil Engineering - Steel Structure Design - Discussion
Discussion Forum : Steel Structure Design - Section 2 (Q.No. 4)
4.
If the depth of the section of an upper column is smaller than the lower column
Discussion:
9 comments Page 1 of 1.
Anurag Singh said:
8 years ago
If the flange thickness of two column is different than before Uses of splice plate fill the gap of lower thickness with the filler plate.
(1)
Roop singh said:
7 years ago
I think A is the right answer.
(1)
Matadi said:
9 years ago
Explain the question and answer.
Deepak said:
9 years ago
Please Explain it.
Aamir Salam said:
7 years ago
Filler plates or shims or disc spacers are used to fill the gap to connect the beam or other structure to beam in order to bring it or raise it to the required height.
Bhushan said:
7 years ago
But what about bearing plates are they used or not?
V.V.savaliya said:
7 years ago
Thank you so much @Anurag and @Aamir.
Jinish said:
6 years ago
Both bearing and filler will b used because bearing plate used as base plate and filler plates used as fill the material and to reduce the section dimension.
Vipan mehta said:
5 years ago
If the thickness of the upper plate is slightly less than the lower plate then we use a filler plate.
But when upper plate thinner & not able to take them in that case we use a bearing plate.
But when upper plate thinner & not able to take them in that case we use a bearing plate.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers