Civil Engineering - Steel Structure Design - Discussion
Discussion Forum : Steel Structure Design - Section 3 (Q.No. 35)
35.
According to the Unwin's formula, if t is thickness of the plate in cm, the nominal diameter of the rivet, is
Discussion:
21 comments Page 2 of 3.
Rajat Dahiya said:
7 years ago
d=6.04√t where t is in mm.
When we change it in cm, 1 cm =10mm.
d=6.04√(t/10) = 1.91√t.
When we change it in cm, 1 cm =10mm.
d=6.04√(t/10) = 1.91√t.
Er. Kawal said:
7 years ago
Correct answer is;
Unwin's formula =6√t.
Unwin's formula =6√t.
Roy said:
7 years ago
6√t mm = 6√{t/10} cm = 1.9√t cm.
(1)
V.V.savaliya said:
7 years ago
Thanks @Roy.
Pankaj said:
7 years ago
1.9√t for cm. 6.05√t is for t in mm.
(1)
Dharun said:
5 years ago
If the thickness of the plate is in mm then the formula is 6.05√t and if the thickness is specified in cm then convert thickness mm to cm and this thickness is in the root.
So if we took root for this and multiple by 6.05 the we will get 1.91√t.
So if we took root for this and multiple by 6.05 the we will get 1.91√t.
Viplove negi said:
5 years ago
Thanks @Roy.
Rohan Mukherjee said:
5 years ago
Well said, thanks @Roy.
Subhendu patra said:
4 years ago
6=d.01*√t, where t=thickness of the smaller plate.
(1)
Vir rawat said:
3 years ago
@All.
First take square in both sides for easy calculation then convert units you will get the answer.
First take square in both sides for easy calculation then convert units you will get the answer.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers