Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 2 (Q.No. 41)
41.
If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than
Discussion:
37 comments Page 3 of 4.
Sohan jangra said:
1 decade ago
I think that it is one third of diameter of largest bar.
George k george said:
1 decade ago
The diameter of the lateral ties should not be less than 1/4th of the diameter of the largest longitudinal bar and in no case less than 6 mm.
So answer is 6mm.
So answer is 6mm.
Venkat Ramana said:
10 years ago
Minimum dimension is 6.0 mm.
Baloch said:
9 years ago
The tie diameter = 1/4th of the main bar.
Ram Praveh yadav said:
9 years ago
The answer should be 6mm.
Lokesh said:
9 years ago
6mm should be in any case.
A D said:
8 years ago
Hav to take Max of both, so answer is 6 mm.
Minesh said:
8 years ago
The Correct answer is C.
Adithya said:
1 decade ago
Diameter of longitudinal bar is one-fourth of maximum diameter in the column, min of 6mm.
Here it 16/4=4 mm or min of 6mm. So answer is 6mm not 5 mm.
Here it 16/4=4 mm or min of 6mm. So answer is 6mm not 5 mm.
Roy said:
8 years ago
The diameter of the polygonal links or lateral ties shall be not less than one-fourth of the diameter of the largest "longitudinal bar, and in no case less than 5mm.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers