Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 2 (Q.No. 41)
41.
If the diameter of longitudinal bars of a square column is 16 mm, the diameter of lateral ties should not be less than
Discussion:
37 comments Page 2 of 4.
Sundaram pandey said:
8 years ago
Answer should be 6mm because there is no standard size of bar available in 5mm.
Maloth Praveen said:
5 years ago
The answer is d/4 i.e 6mm each one is least.
16/4=4.
So the answer is 4mm.
16/4=4.
So the answer is 4mm.
Alok kumar said:
8 years ago
Answer Will be 6. A/c to IS456: The tie diameter = 1/4th of the main bar.
Anik das. said:
7 years ago
Dia of lateral ties should be greater than 5 mm. So, the answer is 6mm.
Jaan said:
6 years ago
Right answer is 6mm because in no case it should be less than 6mm.
Suhil said:
2 years ago
It should be 1/4 dia.of main bar or 6mm which is the maximum.
(4)
Sohan jangra said:
1 decade ago
I think that it is one third of diameter of largest bar.
Priya said:
8 years ago
Diameter of lateral ties should not be less than 5mm.
Vikrant said:
6 years ago
Minbar available is 8mm. So it would be 8mm.
(2)
A D said:
8 years ago
Hav to take Max of both, so answer is 6 mm.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers