Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 1 (Q.No. 49)
49.
The effective width of a column strip of a flat slab, is
Discussion:
14 comments Page 2 of 2.
Hardik said:
6 years ago
@Madhu.
The question is not asking about drop panel.
Here clearly mention column strip Same as in clause 31.1.1 a) of IS 456. So, I think A is the correct option.
The question is not asking about drop panel.
Here clearly mention column strip Same as in clause 31.1.1 a) of IS 456. So, I think A is the correct option.
Divya Dhawan said:
5 years ago
According to IS 456.
31.1.1 For the purpose of this clause, the followingdefinitions shall apply:
a) Column strip - Column strip means a design strip having a width of 0.25 L2, but not greater than 0.25 L1 each side of the columncentre- line, where L1 is the span in the direction moments are being determined, measured centre tocentre of supports and' L2 is th span transverse to measured centre to centre of supports.
31.1.1 For the purpose of this clause, the followingdefinitions shall apply:
a) Column strip - Column strip means a design strip having a width of 0.25 L2, but not greater than 0.25 L1 each side of the columncentre- line, where L1 is the span in the direction moments are being determined, measured centre tocentre of supports and' L2 is th span transverse to measured centre to centre of supports.
Paki said:
4 years ago
Half the width of the panel Or 2 times one-fourth the width of the shortest panel. Please explain.
Tom said:
3 years ago
So with this, what is the width of the half middle strips given unequal span lengths?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers