Civil Engineering - RCC Structures Design - Discussion
Discussion Forum : RCC Structures Design - Section 2 (Q.No. 9)
9.
The radius of a bar bend to form a hook, should not be less than
Discussion:
29 comments Page 1 of 3.
Srinivas said:
10 years ago
Generally 9 times of diameter used for hook.
Gyaneswar said:
10 years ago
For Mild steel twice the diameter.
For Cold worked steel four times the diameter.
For Cold worked steel four times the diameter.
Samm said:
9 years ago
Three times as per, Kurmi Gupta.
Karthika said:
9 years ago
But above question not specified mild steel or cold worked steel. Then how to identify this? Please explain it.
Snehasish said:
9 years ago
It should be four times the diameter.
Shilendra singh said:
8 years ago
The radius of hook= n$ .
Where $=Dia of bar.
n=2 for plain mild steel bar.
n=4 for HYSD bar.
So radius of hook= 2$. So option is correct.
Where $=Dia of bar.
n=2 for plain mild steel bar.
n=4 for HYSD bar.
So radius of hook= 2$. So option is correct.
B S Rana said:
8 years ago
Twice is very less, please clarify.
Nayan said:
8 years ago
Internal radius of the bend is thrice the diameter and the length of straight bar beyond the end of curve should be least four time the diameter of the bar.
Ref. R. S. KHURMI (PAGE - 527).
Ref. R. S. KHURMI (PAGE - 527).
Bipun said:
8 years ago
Yes, you are right @Nayan.
MOHIT agtawal said:
8 years ago
4 time is correct.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers