Chemical Engineering - Process Control and Instrumentation - Discussion
Discussion Forum : Process Control and Instrumentation - Section 6 (Q.No. 11)
11.
Block diagram of a simple standard control system is shown below in the figure.
Which of the following statement about the above control system is wrong ?
Which of the following statement about the above control system is wrong ?
The transfer functions of the measuring element and the process is represent by H and G2 respectively
The overall transfer function for the change in load (X = 0) is given by 
The overall transfer function for the change in set point (X1 = 0) is given by 
Manipulated variable is represented by C.
Discussion:
1 comments Page 1 of 1.
Ashutosh Gupta said:
9 years ago
In this case, the manipulated variable is R.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers