Mechanical Engineering - Strength of Materials - Discussion
Discussion Forum : Strength of Materials - Section 1 (Q.No. 19)
19.
The deformation per unit length is called
Discussion:
11 comments Page 1 of 2.
Ankem Naveen kumar said:
3 years ago
Strain is defined as a change in dimensions to the original dimensions.
So, deformation per unit length is known as strain.
So, deformation per unit length is known as strain.
Anil pandey said:
6 years ago
Dl/l , mm/mm so there unit is zero.
Vivek rai said:
7 years ago
There is only one reason to choose strain is its dimension.
Otherwise, we can't use dL/L as it's explanation, Because here it is written unit length also not told unit length is one.
Otherwise, we can't use dL/L as it's explanation, Because here it is written unit length also not told unit length is one.
Ch venkata gopi nath said:
8 years ago
Strain = Cange in dimensions to orginal dimensions.
Harinadh said:
9 years ago
Deformation to unit length is a dimensionless parameter since strain is a dimensionless parameter. So it is the answer.
Vishal Chauhan said:
10 years ago
Because Deformation means change in dimension so the ratio of change in dimension to original dimension is called strain. Here dimension is length so deformation means change in length over original length.
Ajit sharma said:
1 decade ago
Strain = dL/L, dL = difference of length, L = original length.
Alok said:
1 decade ago
Strain = change in length/original length.
Harish J said:
1 decade ago
Strain = Change in length per original Length(dL\L).
Sheikh inzamamul said:
1 decade ago
dL\L IS RATIO.
Where DL is change in length L is the original length.
Where DL is change in length L is the original length.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers