Technical Drawing - Welding Representation - Discussion
Discussion Forum : Welding Representation - General Questions (Q.No. 2)
2.
These weld symbols have no arrow-side or other-side significance:
Discussion:
3 comments Page 1 of 1.
Keertana said:
1 decade ago
I need explanation to this question.
Pawan said:
6 years ago
Answer D is correct because in this no requirement of symbol welding is done on the whole surface in one cross-section.
Pawan kumar said:
6 years ago
D is correct because flash and upset is done on the entire or whole surface, so not required a symbol.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers