Technical Drawing - Piping Drawings - Discussion
Discussion Forum : Piping Drawings - General Questions (Q.No. 3)
3.
When dimensioning piping drawings, you give the lengths of all runs of this type:
Discussion:
4 comments Page 1 of 1.
Sam said:
8 years ago
If you need any pipe with any diameter you say only the length of the pipe so the dimensioning pipe drawing should be straight.
Den said:
8 years ago
I don't understand please explain it briefly.
Yusuf said:
9 years ago
Yes, the answer is Straight only.
Anil said:
9 years ago
Straight only gives the length not for angular or etc. Example scale.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers