Technical Drawing - Gears and Cams - Discussion
Discussion Forum : Gears and Cams - General Questions (Q.No. 1)
1.
Spur gear design normally begins with selecting this:
Discussion:
5 comments Page 1 of 1.
Si Thu Aung said:
9 years ago
How can I get the solutions of Chapter 17 Gears and Cams exercises?
Kannan said:
10 years ago
Spur gear always mentioned where the dimension in via pitch circle diameter.
Karan said:
1 decade ago
Addendum dedendum are defined from pitch circle diameter.
Sapna said:
1 decade ago
Because Its value is based on the number of teeth, the normal module and the helix angle.
Sambit sahu said:
1 decade ago
Cause gear design always need pitch circle.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers