IndiaBIX

Technical Drawing - Computer Aided Design Basics - Discussion

Discussion Forum : Computer Aided Design Basics - General Questions (Q.No. 5)
Computer Aided Design Basics
5.
When using the direct entry method to create a horizontal line exactly three inches long the drafter should ________ first.
pull the line from away from the starting point very carefully
insure that Ortho is on
enter 3 for the length of the line
read the coordinate position on the Dynamic Readout
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
2 comments Page 1 of 1.
Amit said:   1 decade ago
Because if the ortho is off then we have to put its polar coordinate which is tough as compare to ortho. So to first check ortho is on or not. Once ortho get on, only we have to put a distance of 3 unit.
Dibyaranjan udayasingh said:   1 decade ago
Switching the ortho on helps in creating straight lines.
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers