# Technical Drawing - Computer Aided Design Basics

### Exercise :: Computer Aided Design Basics - General Questions

6.

In order to set drawing limits for a "C" size architectural drawing the drafter should set the limits to ________.

 A. 0,0 and 2,9 B. 0,0 and 17,11 C. 0,0 and 18,24 D. 0,0 and 34,24

Explanation:

No answer description available for this question. Let us discuss.

7.

One quick way to view the entire drawing area is to use the Zoom command by typing ________.

 A. type Z enter A enter B. type Z enter E enter C. type SHOWALL enter D. type ALL enter

Explanation:

No answer description available for this question. Let us discuss.

8.

When setting up a mechanical drawing in AutoCAD the drafter should set the units to ________.

 A. fractional B. decimal C. architectural D. metric

Explanation:

No answer description available for this question. Let us discuss.

9.

When drawing a line using the relative coordinate system a line is created from ________.

 A. 0,0 B. the ending point of the last line C. the beginning point of the last line D. none of the above

Explanation:

No answer description available for this question. Let us discuss.

10.

If you use the absolute coordinate system to create a line from a starting point of 0, 0 8 units on the X axis and 5 units on the Y axis you enter ________ for the second point.

 A. 8,5 B. 5,8 C. 0,8 D. 5,0