Networking - Wide Area Networks - Discussion

Discussion :: Wide Area Networks - Wide Area Networks (Q.No.14)

14. 

When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the clock rate determined?

[A]. Supplied by the CSU/DSU
[B]. By the far end router
[C]. By the clock rate command
[D]. By the Physical layer bit stream timing

Answer: Option A

Explanation:

Clocking on a serial interface is always provided by the CSU/DSU (DCE device). However, if you do not have a CSU/DSU in your nonproduction test environment, then you need to supply clocking with the clock rate command on the serial interface of the router with the DCE cable attached.

Post your comments here:

Name *:

Email   : (optional)

» Your comments will be displayed only after manual approval.