Networking - IPv6 - Discussion

Discussion Forum : IPv6 - IPv6 (Q.No. 10)
10.
To enable EIGRP, which of the following would you use?
  1. Router1(config-if)# ipv6 ospf 10 area 0.0.0.0
  2. Router1(config-if)# ipv6 router rip 1
  3. Router1(config)# ipv6 router eigrp 10
  4. Router1(config-rtr)# no shutdown
  5. Router1(config-if)# ipv6 eigrp 10
1, 3 and 5
3, 4 and 5
1 and 3
5 only
Answer: Option
Explanation:
Unlike RIPng and OSPFv3, you need to configure EIGRP both from global configuration mode and from interface mode, and you have to enable the command with the no shutdown command.
Discussion:
1 comments Page 1 of 1.

Ram said:   9 years ago
What answer?

Post your comments here:

Your comments will be displayed after verification.