Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 1 (Q.No. 34)
34.
A plug gauge is used to check the diameter of shafts and studs.
Discussion:
23 comments Page 2 of 3.
Navin ahir said:
9 years ago
Plug gauge has used to measure cylindrical bore.
Sanju said:
9 years ago
Which type of bores can be measured using plug gauge?
a) Taper
b) Spherical
c) Cylindrical
a) Taper
b) Spherical
c) Cylindrical
Kuldeep kumar said:
9 years ago
For this purpose, the ring gauge is used.
Ashil patel said:
9 years ago
Ring gauge is used for checking the diameter of shafts and studs.
Ashish Gupta said:
10 years ago
It is used to check bore diameter with in tolerance.
It ensure by go and not go gauge size.
It ensure by go and not go gauge size.
Abhishek said:
1 decade ago
Ring gauge is used to check external diameter of shaft, and snap gauge is used to check external diameter of shaft and square objects.
Abhiahek said:
1 decade ago
Plug gauge is used to check inner diameter of a pipe.
Lekhya said:
1 decade ago
Plug gauge is used to check the internal diameter of hole, where as ring gauge issued to check the external diameter of shaft.
Vinit said:
1 decade ago
Ring gauge is used for this purpose.
GOVIND JADHAV said:
1 decade ago
Plug gauges are used to measure only internal diameter of hole, for measuring external diameter of shaft/stud snap gauges uses.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers