Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 4 (Q.No. 10)
10.
Which of the following welding method uses a pool of molten metal?
Discussion:
11 comments Page 1 of 2.
SATYENDRA CHAUDHARY said:
6 years ago
The right answer is electro slag welding.
(2)
Sakthi said:
9 years ago
Actually the answer should be Electro Slag Welding. Because it only uses pool of molten metal.
(1)
Manhar said:
1 decade ago
Mig & saw welding is same but mig is gas use & saw is flux us but both welding use in steel.
Pravin said:
9 years ago
You are right @Sakthi.
Devendra said:
9 years ago
Yes, I too think electro slag is more correct.
Saumya rani said:
9 years ago
Yes, I also agree. Weld pool is also used in arc welding but in electro slag welding is only use of molten metal.
Saroj said:
8 years ago
Electroslag is the right answer.
Arun said:
8 years ago
Electroslag welding is the best answer.
Sunny Singh said:
6 years ago
Answer is Electro slag welding.
Gujarat Kumar(vipul) said:
6 years ago
Electro Slag weld is right.
Because;
The Submerged-arc welding (SAW) is the formation of an arc between a continuously fed electrode and the work piece.
A blanket of powdered flux, which generates a protective gas shield and a slag -- and may also be used to add alloying elements to the weld pool), protects the weld zone.
Because;
The Submerged-arc welding (SAW) is the formation of an arc between a continuously fed electrode and the work piece.
A blanket of powdered flux, which generates a protective gas shield and a slag -- and may also be used to add alloying elements to the weld pool), protects the weld zone.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers