Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 6 (Q.No. 3)
3.
The punch and die set up is __________ for punching and piercing operation.
Discussion:
4 comments Page 1 of 1.
Likith said:
7 years ago
The answer is right there is only about 2mm difference between a punch and die. It is about it's set up not it's dimensions.
Mahesh said:
8 years ago
It's worng answer because punch and die are same then how product coming?
Explain it cleaarly.
Explain it cleaarly.
Krishna said:
3 years ago
For punching clearance is punch.
& For piercing operation clearance is die.
& For piercing operation clearance is die.
Akhil said:
8 years ago
Yes, you are right, there is no any similar relation between them.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers