Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 2 (Q.No. 19)
19.
In sheet metal work, the cutting force on the tool can be reduced by
Discussion:
26 comments Page 2 of 3.
Neel said:
9 years ago
I too think the answer is C.
Junaidjamal said:
9 years ago
The right answer is option C.
Carnot said:
9 years ago
Yes, Answer would be C.
Ranjit said:
8 years ago
C is the correct answer.
Kathiravan said:
8 years ago
The tool end sharp edges then only cut the workpiece.
Ravi said:
7 years ago
As per my knowledge, the correct answer is C.
Md Arbaj said:
7 years ago
Yes, shear angle is the right answer.
Rajat said:
6 years ago
A option is right.
As f = blanking area * shear stress.
As area decreases, force will also decreases.
As f = blanking area * shear stress.
As area decreases, force will also decreases.
Prakash tiwari said:
6 years ago
C is correct. I too agree.
Mayur said:
5 years ago
The Correct answer is C by proving shear the force is reduced.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers