Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 3 (Q.No. 21)
21.
The operation of cutting a cylindrical hole in a sheet of metal by the punch and die is called
Discussion:
31 comments Page 2 of 4.
SILAPARASETTI RAVITEJA said:
9 years ago
Yes, guys absolutely correct the answer is punching
Ritesh Mahajan said:
9 years ago
Punching is the right answer.
Brijesh kumar said:
9 years ago
Punching is the correct answer.
MAHARAJA said:
8 years ago
To cutting a non cylindrical hole on sheet metal.
Abhilash said:
8 years ago
Option C is the correct answer.
Prabhanjan pandey said:
8 years ago
I think Option C is correct.
Ajay Modh said:
8 years ago
Option C-Punching is the right answer.
Please Refer R. S. Khurmi.
Please Refer R. S. Khurmi.
Akashdeep ekka said:
8 years ago
Puching is the right answer because in question asking about cylindrical hole not an only hole. Piercing is a process making any kind of hole instead cylindrical hole.
Raj k Kumar said:
8 years ago
Yes, punching is the correct answer.
Akash said:
8 years ago
Yes, punching is the right answer.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers