Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 1 (Q.No. 8)
8.
The draft or taper allowance on casting is generally
Discussion:
17 comments Page 1 of 2.
Dhruv said:
10 years ago
Which means tapper section is provided only perpendicular face with parting line?
Er. Akshay said:
9 years ago
The amount of draft depends upon the length of Vertical side of the pattern to be extracted, the intricacy(Complexity) of the pattern, the method of molding and pattern material.
Shakti kumar said:
9 years ago
Please explain this question.
Dhaval suthar said:
9 years ago
I think the answer is 10-15mm/m.
Arjun Kumar said:
9 years ago
Provided draft allowance 10-15mm/mtr on casting vertical sides.
Surya said:
9 years ago
In, Rs Khurmi 1 to 2 but RK Jain 10 to 15.
Which is the correct answer?
Which is the correct answer?
DEEP said:
8 years ago
10 to 15 is correct.
Rahul saini said:
8 years ago
How you can say @Deep?
Sanjay dutta said:
8 years ago
Please explain this answer to get it.
Vilish said:
8 years ago
Answer is C.
Outer taper is 10 to 25.
Inner taper is 40 to 65.
Outer taper is 10 to 25.
Inner taper is 40 to 65.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers