Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 1 (Q.No. 49)
49.
When a pattern is made in three parts, the bottom part is known as a cope.
Discussion:
10 comments Page 1 of 1.
Bharvad sir said:
5 years ago
Three parts of moulding flask are generally specified.
* Top moulding flask is known as cope.
* Intermediate moulding flask is cheek.
* Bottom moulding flask is drag.
* Top moulding flask is known as cope.
* Intermediate moulding flask is cheek.
* Bottom moulding flask is drag.
(3)
Sai SIMHADRI said:
5 years ago
When we make three-piece pattern.
Upper case is 1. Cope box.
Middle Case is 2. Cheek box.
Lower case is 3. Drag box.
Upper case is 1. Cope box.
Middle Case is 2. Cheek box.
Lower case is 3. Drag box.
(3)
BUDDHADEV SASMAL said:
7 years ago
It is Cope, cheek, drag.
LAXMAN PURI said:
9 years ago
The bottom part is known as drag.
Aditya Sokashi said:
9 years ago
Upper part cope lower part is drag.
RSamota said:
9 years ago
Upper box is cipe.
Lower box drag.
Middle cheak.
Lower box drag.
Middle cheak.
Keshar bisht said:
1 decade ago
In pattern cope part is upper. Cheek part is center and drag part is bottom.
Sathish kumar said:
1 decade ago
Upper box - cope box.
Lower box - drag box.
Lower box - drag box.
JAINITH said:
1 decade ago
Upper part - cope.
Middle part - cheek.
Bottom part - drag.
Middle part - cheek.
Bottom part - drag.
SANTOSH said:
1 decade ago
In sand casting, upper part is known as cope and lower part is known as drag.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers