Mechanical Engineering - Workshop Technology - Discussion
Discussion Forum : Workshop Technology - Section 2 (Q.No. 20)
20.
In order to get uniform thickness of the plate by rolling process, one provides
Discussion:
19 comments Page 1 of 2.
Asif khan said:
1 decade ago
Cambering is done for uniform thickness.
AMAL said:
10 years ago
Yes cambering is done for uniform thickness.
TUSHAR said:
9 years ago
Camber is correct answer.
Rushikesh Patil said:
9 years ago
Yes, And A is the Correct answer.
Yogesh said:
9 years ago
Yes, the correct answer is cambering.
Ajay gupta said:
8 years ago
A is 100% right answer. I agree with it.
RAHUL said:
8 years ago
What is this camber? Please explain.
Ali said:
7 years ago
Camber angle is the measure in degrees of the difference between the wheels vertical alignment perpendicular to the surface. If a wheel is perfectly perpendicular to the surface, its camber would be 0 degrees. Camber is described as negative when the top of the tires begin to tilt inward towards the fender wells. Consequently, when the top of the tires begin to tilt away from the vehicle it is considered positive.
Biswaranjan Nayak said:
7 years ago
Answer is C. According to Rs Khurmi
Saptarshi said:
7 years ago
The correct Answer is C (Ref: Khurmi & Gupta).
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers