Mechanical Engineering - Thermodynamics - Discussion
Discussion Forum : Thermodynamics - Section 1 (Q.No. 2)
2.
A cycle consisting of one constant pressure, one constant volume and two isentropic processes is known as
Discussion:
41 comments Page 4 of 5.
ANANTHAN said:
9 years ago
It is diesel cycle because it has one constant volume and pressure process.
Parthikkumar patel said:
9 years ago
Actually its dual cycle.
BISWABHUSAN RATH said:
10 years ago
Otto cycle have two constant volume diesel cycle have one one constant volume and one constant pressure possess.
Sumit kumar said:
1 decade ago
Obviously answer is D.
As in diesel cycle one is cost. Pressure and one is cons. Volume 2 process are adiabatically compression and expansion (because all practical cycle are reversible) and in reversible cycle adiabatic = isotropic process.
As in diesel cycle one is cost. Pressure and one is cons. Volume 2 process are adiabatically compression and expansion (because all practical cycle are reversible) and in reversible cycle adiabatic = isotropic process.
K s prithiviraj said:
1 decade ago
Higher efficiency that cannot engine isotropic compressor and isothermal expansion but it not satisfied to nowadays so diesel engine was used.
K Y NAGENDRA said:
1 decade ago
Process 1 to 2 is isentropic compression of the fluid (blue). cp/cv = 1.4.
Process 2 to 3 is reversible constant pressure heating (red). w = 0.
Process 3 to 4 is isentropic expansion (yellow). cp/cv = 1.4.
Process 4 to 1 is reversible constant volume cooling (green).
Actually it's dual cycle because Otto cycle only constant volume cycle & diesel cycle is constant process cycle. So the answer is dual cycle.
Process 2 to 3 is reversible constant pressure heating (red). w = 0.
Process 3 to 4 is isentropic expansion (yellow). cp/cv = 1.4.
Process 4 to 1 is reversible constant volume cooling (green).
Actually it's dual cycle because Otto cycle only constant volume cycle & diesel cycle is constant process cycle. So the answer is dual cycle.
K sushma reddy said:
1 decade ago
Process 1 to 2 is isentropic compression of the fluid (blue).
Process 2 to 3 is reversible constant pressure heating (red).
Process 3 to 4 is isentropic expansion (yellow).
Process 4 to 1 is reversible constant volume cooling (green).
Process 2 to 3 is reversible constant pressure heating (red).
Process 3 to 4 is isentropic expansion (yellow).
Process 4 to 1 is reversible constant volume cooling (green).
Dinesh kumar kumawat said:
1 decade ago
Please correction vipul that work is not obtain at const vol but in adiabatic expansion process.
Vipul said:
1 decade ago
Its. Diesel cycle. Because in diesel cycle heat is supplied to the system at constant pressure. but heat rejected or work obtained at constant volume process. And rather than the two process. I reversible isentropic process is also there.
Loki said:
1 decade ago
Actually it should be duel cycle diesel do not have both constant pressure and constant volume both only constant pressure.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers