Mechanical Engineering - Strength of Materials - Discussion
Discussion Forum : Strength of Materials - Section 3 (Q.No. 14)
14.
The ratio of the largest load in a test to the original cross-sectional area of the test piece is called
Discussion:
4 comments Page 1 of 1.
Anomie said:
4 years ago
Then for which stress do we take the final cross-section area?
Joy said:
6 years ago
Because only in case of ultimate stress, the load will be maximum.
For breaking stress again load will decrease from the maximum.
Refer stress-strain diagram to understand easily.
For breaking stress again load will decrease from the maximum.
Refer stress-strain diagram to understand easily.
Anupam said:
7 years ago
Can anyone explain it?
Sonali yadav said:
8 years ago
Please explain it.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers