IndiaBIX

Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 1 (Q.No. 40)
Production Engineering
40.
In up milling, the thickness of chip is
minimum at the beginning of the cut and maximum at the end of the cut
maximum at the beginning of the cut and minimum at the end of the cut
uniform throughout the cut
none of these
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
13 comments Page 2 of 2.
Anwar said:   8 years ago
The chip thickness starts at zero and increases toward the end of the cut. Cutting forces tend to push the cutter and workpiece away from each other. ANSWER A is right.
Vijay said:   7 years ago
A is the correct answer.
Hayagreeva said:   7 years ago
I think option B is wrong.

And this up milling is also called CONVENTIONAL MILLING.
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers