Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 46)
46.
The angle included between the two lips projected upon a plane parallel to the drill axis and paralled to the two cutting lips, is called helix angle.
Discussion:
6 comments Page 1 of 1.
CHUDASAMA DEVEN said:
3 years ago
The angle included between the two lips projected upon a plane parallel to the drill axis and paralled to the two cutting lips, is called helix angle.
(2)
Vicky said:
7 years ago
Could you explain briefly?
(1)
Snehi said:
8 years ago
It is the angle between the axis of the drill and the direction of the flute (thread in simple terms) of the the drill. It provides passage to the drilled chips to go out of the drilled hole.
(2)
Ritesh Panchal said:
9 years ago
@Banty
The angle included between the two lips projected upon a plane parallel to the drill axis and parallel to the two cutting lips, is called point angle.
The angle included between the two lips projected upon a plane parallel to the drill axis and parallel to the two cutting lips, is called point angle.
(1)
Banty said:
1 decade ago
The information is for Point angle.
(2)
Ahir haresh said:
1 decade ago
In any square the threads are made some angles, the angular distance between work piece surface or perpendicular surface of drill axis.
(1)
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers