Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 38)
38.
Which of the following statement is incorrect with reference of lathe cutting tools?
Discussion:
11 comments Page 1 of 2.
Shivam said:
4 years ago
Thanks @L Padhan.
Shrivardhan said:
5 years ago
Heel is the curved portion where flank and base meets.
L padhan said:
8 years ago
HEEL-It is the intersection of the flank & base of the tool. It is curved portion at the bottom of the tool.
(2)
L Padhan said:
8 years ago
Heel is the Edge between Side flank and bottom face.
(1)
S Bera said:
8 years ago
I think heel is the bottom point of flank.
Gopinath said:
9 years ago
CUTTING TOOL consists of main 4 parts, SHANK, FLANK, FACE, NOSE.
SHANK: It is the main body of the cutting tool which is gripped into the tool holder.
FLANK: It is the surface adjacent to, and below the cutting edge when tool lies in a horizontal position.
FACE: It is the top surface of the tool over which chip will flow.
NOSE: It is the tip of the cutting tool. It formed by the intersection of side cutting edge and end cutting edge. Nose radius ranges from 0.4 to 1.6 mm.
SHANK: It is the main body of the cutting tool which is gripped into the tool holder.
FLANK: It is the surface adjacent to, and below the cutting edge when tool lies in a horizontal position.
FACE: It is the top surface of the tool over which chip will flow.
NOSE: It is the tip of the cutting tool. It formed by the intersection of side cutting edge and end cutting edge. Nose radius ranges from 0.4 to 1.6 mm.
(1)
Avinash Chander said:
9 years ago
Please explain with clear diagram.
Partha Gope Maji said:
9 years ago
Please give a full description with a diagram.
James said:
10 years ago
Heel is the intersection of the flank and the base of the tool.
Sachin said:
1 decade ago
There may be no such part as 'heel' in tool. :-).
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers