Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 5 (Q.No. 13)
13.
The grooving is an operation of
Discussion:
1 comments Page 1 of 1.
Rajesh Kannan m said:
7 months ago
Bevelling the end of a workpiece - Chambering.
Embossing a diamond-shaped pattern on the surface of a workpiece - Knurling.
Reducing the diameter of a workpiece over a very narrow surface -grooving.
Enlarging the end of a hole cylindrically - Boring.
Embossing a diamond-shaped pattern on the surface of a workpiece - Knurling.
Reducing the diameter of a workpiece over a very narrow surface -grooving.
Enlarging the end of a hole cylindrically - Boring.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers