Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 6 (Q.No. 44)
44.
The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is
D - d
Discussion:
17 comments Page 2 of 2.
Ajit said:
8 years ago
It is (D - d )*L / 2l.
Ajaypal said:
8 years ago
The given option C is correct.
Tail Stock set over = (D-d)/2 *L/l
where L = overall length,
& l = Length of tapered section.
In question, Tail Stock Set Over FOR ENTIRE LENGTH has been asked means L/l = 1
and hence option C is Right.
Tail Stock set over = (D-d)/2 *L/l
where L = overall length,
& l = Length of tapered section.
In question, Tail Stock Set Over FOR ENTIRE LENGTH has been asked means L/l = 1
and hence option C is Right.
Dharmesh said:
8 years ago
D-d/2L is the correct answer.
Alif charniya said:
9 years ago
You are right @@Rahul.
Pravin said:
9 years ago
Yes, agree with you @Rahul and @Abdul.
Abdul said:
10 years ago
tan0 = (D-d/2)/L.
Rahul dhaker said:
1 decade ago
It will be D-d/2L.
This is the right for taper turning.
This is the right for taper turning.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers