Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 6 (Q.No. 37)
37.
With the same tool life, the maximum material per minute is removed by
Discussion:
4 comments Page 1 of 1.
Mayur said:
5 years ago
If you increase any of those terms tool life will decrease but they are talking about max material removal so obviously it is high Dept of cut.
Rajendra said:
6 years ago
Exactly C... Y because if you increase the speed, the tool life will decrease based on the Taylors tool life equation...VT ^n = C.
Bhanu Pratap said:
9 years ago
The correct answer should be [c] only.
Bhanu Pratap said:
9 years ago
If you increase the depth of cut, tool life will decrease.
Therefore answer should be [A]. Increasing the cutting speed.
Therefore answer should be [A]. Increasing the cutting speed.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers