Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 3 (Q.No. 21)
21.
The surface finish is improved by the increase in
Discussion:
6 comments Page 1 of 1.
Raja said:
4 years ago
Cutting speed if increase, then the surface does not obtain as good.
Tarun said:
5 years ago
Small nose radius - increase surface finish and tool life.
Large nose radius - increase strength of the tool.
Large nose radius - increase strength of the tool.
(1)
Sumit kumar said:
7 years ago
The Cutting speed we know doubt is for nose radius we know that;.
H= f^2/8r.
Increasing nose radius also the surface finish improves. Hence answer is correct. Option D justified.
H= f^2/8r.
Increasing nose radius also the surface finish improves. Hence answer is correct. Option D justified.
Debarpan said:
7 years ago
The Answer will be nose radius.
Abdul said:
10 years ago
With increasing cutting speed the surface finish is very poor because the operation is not smooth.
With increasing nose radius the contact area between tool and workpiece is more. So maximum surface finish will be produced.
With increasing nose radius the contact area between tool and workpiece is more. So maximum surface finish will be produced.
Ashish Gupta said:
10 years ago
I think with the increase in nose radius surface finish will decrease.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers