Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 6 (Q.No. 9)
9.
Small nose radius
Discussion:
7 comments Page 1 of 1.
Ganeshr said:
4 years ago
Right, thanks @Mayur.
Mayur said:
5 years ago
The answer should be B and D as nose radius reduces strength also get reduced and that is why chances of getting wear of tool increases therefore tool life decreases.
Guru said:
6 years ago
The area of HT become less & stress concentration because the edge becomes sharp.
Sumit said:
7 years ago
I think C is the correct one.
Abu Horaira said:
8 years ago
Why greater heat generation?
Neeraj said:
8 years ago
Both B and C are right.
Ashish said:
8 years ago
B also the correct answer.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers