Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 5 (Q.No. 40)
40.
Relief angles on high speed steel tools usually vary from
Discussion:
21 comments Page 1 of 3.
Abdul hamid said:
6 years ago
According to me, It's varied from 5° to 15°.
(1)
Sham malik said:
6 years ago
B should be the answer.
(1)
Santosh Kumar said:
7 years ago
Answer is 3 to 5°.
Vijay said:
6 years ago
The right answer is 3° to 5°.
For carbide tipped tools is - 3° to 10°.
For carbide tipped tools is - 3° to 10°.
Saurabh said:
6 years ago
How D? Explain please.
Vinay kumar said:
6 years ago
It should be 3° to 5°.
Dhananjay Bhile said:
7 years ago
The answer is 3° to 5°.
Relief angle on carbide tipped tools is 3° to 10°.
Relief angle on carbide tipped tools is 3° to 10°.
Kripa said:
7 years ago
The range is 3° to10°.
Sameer said:
7 years ago
3°-10° is the correct answer.
Chandra kant said:
7 years ago
I think 10 to 20 is the right answer.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers