Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 4 (Q.No. 30)
30.
Side relief angle of a single point tool is the angle
by which the face of the tool is inclined towards back
by which the face of the tool is inclined sideways
between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool
between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
8 comments Page 1 of 1.

Biswajit said:   6 years ago
It should mention which flank. Side flank or end flank ?

Harshit said:   6 years ago
D is the right answer.

Dhaval Chaudhary said:   6 years ago
C is the correct answer.

Ref: RS Kurmi.

Kundan said:   6 years ago
Right answer is C because D is for end relief angle.

Dinesh said:   6 years ago
Why not D?

Vilish said:   7 years ago
D is right. I also agree.

Prashant said:   8 years ago
Yes, D is the correct answer.

Neeraj said:   8 years ago
I think D is the right answer.

Post your comments here:

Your comments will be displayed after verification.