Mechanical Engineering - Production Engineering - Discussion
Discussion Forum : Production Engineering - Section 1 (Q.No. 13)
13.
A single point thread cutting tool should ideally have
Discussion:
16 comments Page 2 of 2.
Adarsh shukla said:
9 years ago
Can we give zero clearance angle in single point cutting tool?
Pushkar said:
9 years ago
If we use positive rake angle then the chip flowing sideward direction will induce a thrust force on threads and produce crack and thread become weak.
(3)
Vipin Kumar said:
8 years ago
It is B.
A threading tool should IDEALLY have positive rake because it will give good chip flow control. Better chip flow results in better quality threads with less burrs and scratches.
A threading tool should IDEALLY have positive rake because it will give good chip flow control. Better chip flow results in better quality threads with less burrs and scratches.
(2)
Vicky said:
8 years ago
From which refrence point The Rake angle is measure that is either positive or negative decided?
Sabir said:
7 years ago
It should ideally have positive rake angle.
GOLLU NAGENDRA said:
5 years ago
From which reference point, The Rake angle is a measure that is either positive or negative decided?
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers