Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 3 (Q.No. 49)
In oblique cutting system, the maximum chip thickness
occurs at the middle
may not occur at the middle
depends upon the material of the tool
depends upon the geometry of the tool
Answer: Option
No answer description is available. Let's discuss.
2 comments Page 1 of 1.

Shrivardhan said:   3 years ago
In orthogonal cutting, chip thickness is maximum at the middle.

Manoj said:   9 years ago
In oblique cutting system, the chip thickness is same from start to end.

Post your comments here:

Your comments will be displayed after verification.