IndiaBIX

Mechanical Engineering - Production Engineering - Discussion

Discussion Forum : Production Engineering - Section 2 (Q.No. 22)
Production Engineering
22.
The factor responsible for the formation of continuous chips with built up edge is
low cutting speed and large rake angle
low cutting speed and small rake angle
high cutting speed and large rake angle
high cutting speed and small rake angle
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
17 comments Page 2 of 2.
YASH DESAI said:   9 years ago
Answer should be A for continuous chip high rake angle is required.
Rajdip said:   7 years ago
Is Continuous and discontinuous a similar factor?
Nipam nath said:   9 years ago
It should be C. High speed and large rake angle.
Neeraj said:   8 years ago
C is the correct answer. No doubt.
Abhi said:   9 years ago
The answer should be 'D'.
Debarpan said:   7 years ago
The answer should be C.
Apurv said:   9 years ago
Answer should be D.
Post your comments here:

Your comments will be displayed after verification.

Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers