Mechanical Engineering - Machine Design - Discussion
Discussion Forum : Machine Design - Section 9 (Q.No. 27)
27.
If T1 and T2 are the tensions on the tight and slack sides of the belt respectively, and Tc is the centrifugal tension, then initial tension in the belt is equal to
T1 - T2 + Tc
T1 + T2 + Tc
Discussion:
5 comments Page 1 of 1.
Ganeshr said:
5 years ago
Yes. It should be 2Tc.
Gaurav said:
7 years ago
Yes, It is 2Tc. I too agree.
Guru said:
9 years ago
Yes, 2Tc should be there.
Sagar Wankhade said:
9 years ago
Centrifugal tension must be two times.
Vijay Kumar sahu said:
10 years ago
(T1+T2/2) + Tc = T1 + T2 + 2Tc/2.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers