Mechanical Engineering - Hydraulics and Fluid Mechanics - Discussion

What is nappe?

Here is the answer to your question.

One half of a double cone is called a nappe.

Here, each part is called nappe.

Or

One of the two pieces of a double cone (i.e., two cones placed apex to apex).

Because we are taking pressure downward direction is positive and upward direction is negative.

This air is carried away by the flowing water, which results in creating a negative pressure beneath the nappe. The negative pressure drags the lower side of the nappe towards the surface of the weir wall. This results in more discharge than the normal discharge.

In order the keep the atmospheric pressure in the space below the nappe holes are made through the channel walls which are connected through the pipes to the atmosphere as shown in figure. Such holes are called 'Ventilation' of a weir.

Here we are considering the down side of the nappe is negative and the above portion will be exposed to atmosphere so the option B and C are correct.

Nappe:- it is that part of water which is falls downward from above, over weir.

Three types of nappe:

1. Free nappe.
2. Depressed nappe.
3. Clinging nappe.

In free nappe the water falls away from the weir wall so air gap generate beneath the nappe. This air at atmospheric pressure.

In depressed nappe the air gap remains small so the pressure of air remain below the atmospheric pressure called negative pressure.

But in clinging nappe no air gap remains so no pressure remains because water falls from the weir as a clutched with wall.

The term Nappe when used in relation to hydro-engineering refers to the sheet of water over-topping a dam. It is an important issue in dam construction because unless air can be introduced into the nappe, the vibration of the water can lead to dam failure.

One half of a double cone is called a nappe.

Can any one tell me about the aeration of nappe?

Depressed Nappe:

In this type, a partial vaccum is created between the nappe and the weir. Discharge for such a flow situation is 8 to 10% greater than that with a free nappe.