Mechanical Engineering - Hydraulics and Fluid Mechanics - Discussion
Discussion Forum : Hydraulics and Fluid Mechanics - Section 7 (Q.No. 11)
11.
The divergent portion of a venturimeter is made longer than convergent portion in order to
Discussion:
3 comments Page 1 of 1.
VigneshMohan said:
8 years ago
The venturimeter is always used in a way that the upstream part of the flow takes place through the short conical portion while the downstream part of the flow through the long one.
This ensures a rapid converging passage and a gradual diverging passage in the direction of flow to avoid the loss of energy due to separation. In course of a flow through the converging part, the velocity increases in the direction of flow according to the principle of continuity, while the pressure decreases according to Bernoulli's theorem.
The velocity reaches its maximum value and pressure reaches its minimum value at the throat. Subsequently, a decrease in the velocity and an increase in the pressure takes place in course of flow through the divergent part.
This ensures a rapid converging passage and a gradual diverging passage in the direction of flow to avoid the loss of energy due to separation. In course of a flow through the converging part, the velocity increases in the direction of flow according to the principle of continuity, while the pressure decreases according to Bernoulli's theorem.
The velocity reaches its maximum value and pressure reaches its minimum value at the throat. Subsequently, a decrease in the velocity and an increase in the pressure takes place in course of flow through the divergent part.
Karan said:
9 years ago
I think that only option A is correct.
Kiran said:
7 years ago
I think option A is correct.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers