Mechanical Engineering - Heat Transfer, Refrigeration and Air Conditioning - Discussion

Discussion Forum : Heat Transfer, Refrigeration and Air Conditioning - Section 1 (Q.No. 46)
The critical radius is the insulation radius at which the resistance to heat flow is
none of these
Answer: Option
No answer description is available. Let's discuss.
11 comments Page 1 of 2.

Hassan said:   7 years ago
Adding insulation to a cylindrical pipe or a spherical shell, however, is a different matter than normal insulation on the wall. Because additional insulation increases the conduction resistance of the insulation layer, But decreases the convection resistance of the surface, because of increase in the outer surface area for the convention.

The thickness up to which heat flow increase and after that heat flow decrease is termed as "Critical thickness" For pipes, ri is taken higher than (ro) cr, so that any insulation added will only decrease the heat loss from the pipe. And For wire s and cables "ri" kept lower than (ro) cr, so that add of insulation increases the heat loss from the wire/ cable.

Dharmender said:   3 years ago
As insulation is added to reduce heat loss pipe so at critical insulation the resistance to heat flow (means heat loss) is maximum above critical insulation heat loss increased due to increase in conduction and below critical radius heat loss increase due to convection.

Ram said:   6 years ago
According to the question, Is Critical radius is the Critical radius of insulation?

Because if it is so then as 'critical Radius of insulation' is there then it will offer maximum resistance to heat flow and minimum heat flow. So option A would be right one.

AMAL said:   8 years ago
The heat transfer at critical radius is maximum and after that it decreases. This concept is used for wires, steam pipe insulation. So at critical temp the thermal resistance is minimum while heat transfer is maximum.

SUV said:   4 years ago
A critical radius is one in which heat flow is maximum. Thus resistance will be obviously minimum. The answer is B.

Puneet said:   7 years ago
If heat transfer should be maximum, then why they use a thermal insulation in a system?

Rakesh kumar said:   9 years ago
q(heat transfer) should be maximum.
So thermal resistance should be minimum.

Alan said:   9 years ago
Is it talking about heat flow to surrounding or through pipe?

Amit Palve said:   3 years ago
The Correct option should be option A.

Niko said:   4 years ago
A is the correct answer.

Post your comments here:

Your comments will be displayed after verification.