Electronics - Series Circuits - Discussion
Discussion Forum : Series Circuits - General Questions (Q.No. 21)
21.
If a voltage is connected between contacts 2 and 3 in the given circuit, which resistors will carry current?
Discussion:
11 comments Page 1 of 2.
Sasi said:
5 years ago
R2 and R6 have no connection between them, right? Please explain the answer.
CJAP said:
7 years ago
R6, R2, R4 and R11 are all connected in series.
See it this way: from R6 (top board) the elongated path connects to R2 (at the bottom board) by another jumper/elongated path (the slanted one at the right. And obviously, R2 and R4 are connected (top board) , and when you see the bottom board, the connected of R4 (second from the left) has also this jumper connecting to the R11 (contact 3, bottom board).
See it this way: from R6 (top board) the elongated path connects to R2 (at the bottom board) by another jumper/elongated path (the slanted one at the right. And obviously, R2 and R4 are connected (top board) , and when you see the bottom board, the connected of R4 (second from the left) has also this jumper connecting to the R11 (contact 3, bottom board).
VISHAL BAWASKAR said:
7 years ago
@All.
Please see the bottom circuit and compare with top circuit. It shows that when vtg is connected to the contact 2 then it will pass to the R2 through jumper and resistor R2 is connected to the R4.
And as shown in the top circuit the vtg is connected to the R3 also so the current carrying resistors are R2, R4, R6 &R11.
Please see the bottom circuit and compare with top circuit. It shows that when vtg is connected to the contact 2 then it will pass to the R2 through jumper and resistor R2 is connected to the R4.
And as shown in the top circuit the vtg is connected to the R3 also so the current carrying resistors are R2, R4, R6 &R11.
PANINDRA.B said:
9 years ago
Please give me correct answer am totally confused.
Tushar Ravan said:
9 years ago
A figure is Right. The answer is also right. Draw the circuit diagram as shown.
Balasabarish said:
10 years ago
I think given figure different from top and bottom pin.
Armandwish said:
1 decade ago
Not satisfied answer. No connection between R2 & R6.
D.D.Hari Krishna said:
1 decade ago
Just follow the past in both top and bottom boards.
Top board follow the resistors and in bottom one follow the shots.
Top board follow the resistors and in bottom one follow the shots.
Satish kumar said:
1 decade ago
If voltage is applied to contact 2 which is connected to R6 from R6 it is connected to R2 (see bottom board "/" connection) , R2 is connected to R4 (see top board) , from R4 to R11 (see bottom board).
Priyanka said:
1 decade ago
Please see the short circuit connections.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers