Electronics - Bipolar Junction Transistors (BJT) - Discussion
Discussion Forum : Bipolar Junction Transistors (BJT) - General Questions (Q.No. 2)
2.
Three different Q points are shown on a dc load line. The upper Q point represents the:
Discussion:
20 comments Page 1 of 2.
Sindhu said:
5 years ago
It's minimum current gain!
Because when a transistor is biased in the saturation mode, Ic<(beta x Ib).
This condition is very often used to prove that a transistor is biased in saturation mode.
Reference: Electronics Circuits Analysis and design by Donald A Neaman (Third Edition)
Because when a transistor is biased in the saturation mode, Ic<(beta x Ib).
This condition is very often used to prove that a transistor is biased in saturation mode.
Reference: Electronics Circuits Analysis and design by Donald A Neaman (Third Edition)
(1)
Bikram said:
1 decade ago
There are three region on Q-point, the lower one is cut-off, midle one is active and the upper most region is saturation and also y-axis represents current n x-voltage. So saturation n current axis means max. Current.
Alew said:
2 years ago
Please explain the answer clearly with the Venn diagram.
Kona lakshman said:
9 years ago
Is Dc characteristics of BJT for NPN and PNP is same? Anyone please explain.
J Ramya said:
10 years ago
Upper part means saturation region. In saturation region output junction is also forward biased. So maximum current flows that's the why current gain is high.
Anubhav chaturvedi said:
1 decade ago
There is a very simple reason - plotting dc load line you see that y axis is for output current while x axis is for output voltage. According to given condition upper Q point implies maximum output voltage, hence maximum gain.
Akshay said:
1 decade ago
-> Current gain = B(beta) = Ic/Ib.
-> Upper Q-Point denotes higher Ic.
-> Thus for const. Ib.
-> B(beta) Must be high.
-> Upper Q-Point denotes higher Ic.
-> Thus for const. Ib.
-> B(beta) Must be high.
RajaMohan said:
1 decade ago
Q-Point is drawn by a linear line from Ic to Vce so as q point is moving up it is moving towards High Current and Low voltage so the current is maximum.
Vishal said:
1 decade ago
As I is leading voltage Upper q-pt be max current.
Sravani said:
1 decade ago
x-axis of transfer characteristics of transistor is VCE and y-axis is IC so peak or highest point on the why axis is the point of maximum collector current or output current. So this the point of maximum current gain (ic/ib) in case of ce mode.
Post your comments here:
Quick links
Quantitative Aptitude
Verbal (English)
Reasoning
Programming
Interview
Placement Papers