Electronics - Basic Op-Amp Circuits - Discussion

Discussion Forum : Basic Op-Amp Circuits - General Questions (Q.No. 13)
13.
A two-pole high-pass active filter would have a roll-off rate of
40 dB/decade
–40 dB/decade
20 dB/decade
–20 dB/decade
Answer: Option
Explanation:
No answer description is available. Let's discuss.
Discussion:
19 comments Page 1 of 2.

Asad Ali said:   1 decade ago
Friends in question it is clear that the roll off frequency is asked. If you plot a graph of H.P.F than you will see that High pass filter has range in which there is a starting transition and ending transition. On starting transition it is +40db/dec and on ending transition it is -40db/dec.

Meganathan said:   1 decade ago
Dudes your totally opposite because two pole high pass filter would have a roll-off rate is -40db/decade. Single pole high pass filter would have a roll-off rate is -20db/decade. In case of low pass filter means totally opposite.

Tarun said:   1 decade ago
A two-pole low-pass filter has a roll-off rate of 40 dB/decade.

The two RC, each of which introduces a 20 dB/decade rolloff for a total of 40 dB/decade.

f(c)=1/(2*3.14*(r1*r2*c1*c2)^.5)

Roxy said:   4 years ago
It should be +40db/decade since the slope of the curve for a high pass filter is increasing and not decreasing.

-40db/decade should be for a second-order (two-pole) low pass filter.

Kartik said:   1 decade ago
Yes it will be -40db/decade.

High pass active filter will allow to pass a high frequency and block low frequency it will decade a low frequency i.e. -40.

Rushikesh said:   9 years ago
Yeah, it should be +40 dB per decade as because it is high pass filter the gain will increase as frequency Will increase.

Preeti vyas said:   1 decade ago
It should be +40db/decade because high pass only pass the high freq. Signal thus slope is in growing form so it is +40.

Adarsh said:   1 decade ago
It is definitely +40 db/decade because it has the positive slope as it starts to pass only after certain frequency.

VATSALA SHARMA said:   1 decade ago
Ya it should be +40db in case of high pass filter
its -40db in case of low pass filter

Sengar said:   1 decade ago
I think it should be +40, because we are considering only starting transition.


Post your comments here:

Your comments will be displayed after verification.