Digital Electronics - Digital Design

Exercise :: Digital Design - General Questions

11. 

What would be the output voltage of a 7814 voltage regulator?

A. –14 V dc
B. +14 V dc
C. –8 V dc
D. +8 V dc

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

12. 

The purpose of a pull-up resistor is to keep a terminal at a ________ level when it would normally be at a ________ level.

A. LOW, float
B. HIGH, float
C. clock, float
D. pulsed, float

Answer: Option B

Explanation:

No answer description available for this question. Let us discuss.

13. 

Setup time specifies:

A. the minimum time the control levels need to be maintained on the inputs prior to the triggering edge of the clock in order to be reliably clocked into the flip-flop
B. the maximum time interval required for the control levels to remain on the inputs before the triggered edge of the clock in order for the data to be reliably clocked out of the flip-flop
C. how long the operator has to get the flip-flop running before the maximum power level is exceeded
D. how long it takes the output to change states after the clock has transitioned

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

14. 

Can the automatic RC circuit be used to set a flip-flop rather than reset the flip-flop?

A. yes
B. no

Answer: Option A

Explanation:

No answer description available for this question. Let us discuss.

15. 

A Schmitt trigger:

A. has two trip points
B. is a zero crossing detector
C. has positive feedback
D. has two trip points and positive feedback

Answer: Option D

Explanation:

No answer description available for this question. Let us discuss.